Topaz 1" Inlet Partfill is a high flow valve intended for use in rainwater harvesting tanks. The purpose of the float valve is to automatically maintain a low level of water in the tank during periods of no or low rainfall. This allows services fed by the tank to continue while leaving capacity in the tank for refilling by the next rain.

• High recovery rate - up to 90 GPM

DOWNLOAD THE TOPAZ PARTFILL FLIER

Designed for Maintaining Water Levels in:

• Rainwater Harvesting Tanks
• Water Cisterns
• Irrigation Process Applications

Principle of Operation

• The Valve is installed through the sidewall of a storage tank. It should be mounted above the overflow level of the tank to prevent backflow.
• As the tank empties the weighted float travels down the cord and sits on the bottom stop to activate the valve.
• The valve will run until the weighted float lifts clear of the bottom stop.
• The float will then rise as rainwater fills the tank and falls as the tank water is used.
• The Valve will only function at times when rainfall is insufficient to maintain a water level in the tank above the bottom stop.

Features:

• Ideal for use with all makes and models of rain water harvesting tanks
• Compact • Constructed from non corroding materials
• The valve can be locked in off position using the lock off switch
• Up to 150mm differential obtainable (dependant on pressure)
• Detach Valve Seal Access System for quick access to valve seal
• Supplied in the long-tail thread with a back nut
• Up to 100 PSI

TIP: Plumb in a safety overflow pipe into your tank. Follow proper code.